RAM® X-Grip® Universal Phone Holder Assembly and Use Guide

How to Install the RAM® X-Grip® Phone Holder

Learn how to assemble, secure, and properly install your RAM® X-Grip® phone holder. The instructions apply specifically to the X-Grip® cradle and are consistent across all compatible a variety of mounting applications.

What’s Included

  • X-Grip® phone holder cradle (1)

  • Rubber caps (4)

  • Optional safety tether (1)

  • Adhesive tube (1)

Included parts list for the RAM X-Grip Holder

The tether is recommended for rugged environments and open-cockpit applications.

Installation Steps

Step 1: Install the Rubber Caps

Apply a small amount of the included adhesive inside each rubber cap. Press one rubber cap firmly onto the end of each X-Grip® arm. Make sure all four caps are fully seated.

Rubber caps being installed on the arms of a RAM X-Grip phone holder using adhesive

Allow the adhesive to set before inserting your device.

Step 2: Open the X-Grip® Arms & Insert Your Device

Hold the X-Grip® cradle and gently expand the arms to open the holder. The arms are spring-loaded and will contract toward their original position when released.

With the arms expanded, place your phone against the center of the cradle. Position the device so it sits evenly within the holder.

Phone being positioned in the center of a RAM X-Grip holder before securing

Release the arms slowly so they tighten around the device holding it securely in place.

Step 4: Secure the Device with Optional Safety Tether

Insert your device in the RAM® X-Grip®. Connect the center hole of your tether to the ball behind the RAM® X-Grip®. Wrap each corner of the tether around the four corners of your device.

Phone securely held in a RAM X-Grip mount with safety tether

This installation guide applies to all RAM® X-Grip® phone holders used across compatible mounting systems.

Using the Optional Safety Tether

For added security, especially in high-vibration or off-road environments, use the included rubber tether.

Stretch the tether over the front of the device and hook it onto the cradle arms. The tether provides secondary retention without interfering with screen visibility or device access.

Final Safety Check
  • All four rubber caps are installed and secure
  • The device is firmly held and does not shift
  • The tether is properly attached if used

Recheck device security periodically, especially after adjusting the mount or traveling over rough terrain.

Compatibility Notes
  • The X-Grip® is designed to accommodate a wide range of phone sizes
  • Most standard phone cases are compatible
  • Very thick or oversized cases may affect grip strength
  • The safety tether is strongly recommended for motorcycles, ATVs, UTVs, and open vehicles
Frequently Asked Questions

Do I need to use the adhesive on the rubber caps?
No. This is an optional but recommended step. The adhesive helps prevent the caps from coming loose during use and is recommended for long-term reliability.

Is the tether required?
The tether is optional but highly recommended for high-vibration environments or open-cockpit applications.

Can I rotate the phone once installed?
Rotation depends on the mount and arm used. The X-Grip® cradle itself holds the device securely while allowing adjustment through the mounting system.

Newsletter

Stay up to date on what's happening at Gadget Mounts: Special Deals, Sales, New Products and more.